|
- Clean mounting area inside of windshield with rubbing
alcohol and let dry.
- Remove plastic tape from back of mounting strips
on transponder.
- Position transponder as illustrated above based on your
mirror type.
- Press transponder firmly against glass.
Please note that if not properly mounted, the transponder
may not work and may be unlawfully positioned per SEC.77,
Section 26708 of the Vehicle Code
External Transponder Installation Instructions.
Your external transponder is designed to be attached to the
front of your vehicle, on a flat surface. It is screw-mounted
in the area on the front bumper where the license plate would
normally be located.
Position the transponder so that the mounting
holes correspond to the top of the license plate area on the
front bumper of the vehicle.
If the license plate area on your vehicle is
partially obstructed by an overhanging bumper, please consult
with a customer service representative at 800-378-TRAK (8725)
for an alternate mounting location.
Security Mounting
Your transponder is equipped with tamper-resistant
mounting screws with a unique Allen wrench for mounting. Make
sure you keep the wrench in a secure place for future adjustment
or removal of the transponder.
STEP 1 Remove top two screws from license plate.
STEP 2 Position transponder so the mounting
holes in the transponder correspond to the top holes in the
license plate area on the front bumper of the vehicle.
STEP 3 Tighten tamper-resistant screws provided
with the unique Allen wrench to secure transponder to vehicle.
|
